realme 2 not connect to isp [Solved]

[bharat khoth]

realme 2 conect isp ok but when connect usb
always says usb not reconized any solution
i jumper direct box to mobile but problem same


Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.52 (RIFFBOX1), JTAG Manager Version: 1.86
Selected Package: [Oppo Realme 2 RMX1805 V1.00 by <legija>, <RJ-45>, 1 Bit Bus Width (DAT0)]

Connecting to the SD/eMMC Card...OK
Set I/O Voltage reads as 3.23V, SD_CLK Frequency is 649 KHz

Detected eMMC Chip, ID: 0x15/0x00 (GD6BMB), User Area Partition = 0x000747C00000 Bytes (29.12 GB)

Writting to the SD/MMC Card...ERROR
ERROR: SD/MMC Communication Error = 0x71 (0x00000F) at 0x00002F300000. Trying to recover...OK
ERROR: Timeout while waiting for eMMC/SD Write Response. Trying to recover...OK
ERROR: Timeout while waiting for eMMC/SD Write Response. Trying to recover...OK
ERROR: Stopped due to multiple communication errors. Terminating at 0x00002F300000

[Legija]

Do you have ISP adapter ?


You should set VCCQ to 1.8v for starters, and of course desolder CLK resistor if You use USB for power.

[bharat khoth]

problem solve thanks

[.::JYOTIRMAY::.]

problem solve thanks

Brother will you explain how to solve the issue? I am also facing this issue.

[bharat khoth]

after this error i power on mobile and wipe






Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.52 (RIFFBOX1), JTAG Manager Version: 1.86
Selected Package: [Oppo Realme 2 RMX1805 V1.00 by <legija>, <RJ-45>, 1 Bit Bus Width (DAT0)]

Connecting to the SD/eMMC Card...OK
Set I/O Voltage reads as 3.23V, SD_CLK Frequency is 649 KHz

Detected eMMC Chip, ID: 0x15/0x00 (GD6BMB), User Area Partition = 0x000747C00000 Bytes (29.12 GB)

Writting to the SD/MMC Card...ERROR
ERROR: SD/MMC Communication Error = 0x71 (0x00000F) at 0x00002F300000. Trying to recover...OK
ERROR: Timeout while waiting for eMMC/SD Write Response. Trying to recover...OK
ERROR: Timeout while waiting for eMMC/SD Write Response. Trying to recover...OK
ERROR: Stopped due to multiple communication errors. Terminating at 0x00002F300000