HTC M7 pn07100 resurrector...FAILED (ERROR: No response from the RIFF Box.)

[riajul1988]

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG Manager Version: 1.56
Selected Resurrector: [HTC OneM7 (PN0710000) V1.0.4926.46931]

Connecting to the dead body...OK
Detected dead body ID: 0x207150E1 - CORRECT!
Set I/O Voltage reads as 1.81V, TCK Frequency is 1 MHz

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...FAILED
ERROR: No response from the RIFF Box.

[Legija]

Hi,
Make sure to connect NRST and GND pins properly, and to use RTCK sampling rate.

[okions]

show the picture sir pinout

[Legija]

show the picture sir pinout

There is very large button saying "Interface Pinout".
It's very good idea to click it.

[harishhari]

HTC M7 pn07100 resurrector...FAILED (ERROR: No response from the RIFF Box.)
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG MANAGER Version: 1.56
Selected Resurrector: [HTC OneM7 (PN0710000) V1.0.4926.46931]

Connecting to the dead body...OK
Detected dead body ID: 0x207150E1 - CORRECT!
Set I/O Voltage reads as 1.81V, TCK Frequency is 1 MHz

Resurrection sequence started.
ESTABLISH communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...FAILED
ERROR: No response from the RIFF Box.
please help me sirrrrrrrrrrrrrrrr...............................

[~AKSingh~]

HTC M7 pn07100 resurrector...FAILED (ERROR: No response from the RIFF Box.)
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG MANAGER Version: 1.56
Selected Resurrector: [HTC OneM7 (PN0710000) V1.0.4926.46931]

Connecting to the dead body...OK
Detected dead body ID: 0x207150E1 - CORRECT!
Set I/O Voltage reads as 1.81V, TCK Frequency is 1 MHz

Resurrection sequence started.
ESTABLISH communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...FAILED
ERROR: No response from the RIFF Box.
please help me sirrrrrrrrrrrrrrrr...............................

check neat and clean soldering
power supply
length of wires must be short
press power during resurrection

above points may help you

br,

[lilmo20]

also have this problem..

[pundev]

how to fix it???

[pogran]

replace EMMC