zte s160 giving this error what to do?

[sumit070]

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.40 (RIFFBOX1), JTAG Manager Version: 1.62
Selected Target: [QSC1100, 1.90V, TAP0]

Connecting to the QSC1100 target...OK
Detected dead body ID: 0x220B10E1 - IGNORED!
Set I/O Voltage reads as 1.92V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]

Resetting and Halting target...OK

R0 = 0x00000001 R6 = 0xFFFFFFFE R12 = 0x003E92BD
R1 = 0x88004000 R7 = 0xFFFFFFFD R13 = 0x30159998
R2 = 0x80000F10 R8 = 0xFFFFFEC0 R14 = 0x00011561
R3 = 0x00000000 R9 = 0x00000000 R15 = 0x00000000
R4 = 0x300701C0 R10 = 0xFFFFFFFF CPSR = 0x000000D3
R5 = 0x00000000 R11 = 0x00000000

Connecting to the NOR Memory based at 0x00000000...OK
Detected an Initialized FLASH1 Chip, ID: 0x00EC/0x257E (8MB)

Flashing directly the NOR Memory based at 0x00000000...FAILED
ERROR: Read/Write memory failed during H/W Init.

[Legija]

Connect NRST if it's not connected, and of course make sure that GND is connected properly.

[sumit070]

thanks for quick reply sir but my problem solved after selecting cpu model qsc6010

[Legija]

thanks for quick reply sir but my problem solved after selecting cpu model qsc6010

Hehe
Well, I didnt expected that You selected wrong MCU.