Smart Radio CD Grundig

[Rocky]

:iagree:

Can closed, and you push my "thanks" Buton ! :wink5:

[tatillo]

tanks very very very very very very .................................................

:wink5: Fantastic person :hurray: Fantastic person :cheers2: Fantastic person :thumbsup:

You are the best.

I want say tanks for help me, if all people are like you was better for the world.

tanks very very very very very very ................................................. much

[Rocky]

how can digit 1986 code if radio has only 1-2-3-4 button ?
tanks

If you decoder and do not know how to enter code ????
then I'm without anything to say ... :banghead:

[tatillo]

how can digit 1986 code if radio has only 1-2-3-4 button ?
you told me that my programmator is not good for write but if you remember i programmed radio navigation tuareg, remember ? .

can you advise a good programmator for me ?
remember that i asked you software for find code inside the dump ?
now the radio is still in safe.
tanks

[tatillo]

not function, when write error message (No response received)

i tried to verify, error message (verify failed at address 0014h!)

try to read last dump

[Rocky]

You already got the code +++++ 1986 +++++

What is the problem ? You can't enter code ?

[tatillo]

same read

now is same read

[tatillo]

i hope

is very strange, i hope
tanks

[Rocky]

every time that i read return a different dump

Yeesss !arty:

Code +++++ 1986 +++++

[tatillo]

meaby

Maybe it's right dump

[tatillo]

every time that i read return a different dump

[tatillo]

i hope

i tried in all mode but is strange dump.

in pin vcc volt 5

in pin sda volt -065

in pin scl 2.19

[Rocky]

You connect two wire power +12v ? if not try this.
------------
Do not try with normal station soldering -- If you not worked before !

What are the voltage on all pins 1=? 2=? 3=? .... 8=?

[tatillo]

yes i have but now i can't because my hot air soldering iron is lot rumor and now people slip but a can try with normal station soldering.

[Rocky]

Better read to take eeprom from board.

You have hot air soldering iron for out eeprom ? :confused5: