Announcement

Collapse
No announcement yet.

Smart Radio CD Grundig

Collapse
This topic is closed.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    the chip 24c08 there is not in this circuit, the chip that you indicate is L08

    Comment


    • #17
      Originally posted by tatillo View Post
      the chip 24c08 there is not in this circuit, the chip that you indicte is L08
      You should have to be a policeman ... Oh my God !

      L08 = 24L08 = 24c08

      finally understand, or I need upload pictures for you ?

      Comment


      • #18
        ok but which wires i must connect ? (SDA,SCL,WP,VCC - A0,A1,A2,VSS) GND

        I'am not Policeman hahaha
        tanks

        Comment


        • #19
          Originally posted by tatillo View Post
          ok but which wires i must connect ? (SDA,SCL,WP,VCC - A0,A1,A2,VSS) GND

          I'am not Policeman hahaha
          tanks
          What programmator you use ?

          Comment


          • #20
            dump

            I use multitito and ponyprog 24xx,25xx,3xx v1.0

            I hope that this dump is right.

            I have some problem to read, sometime the programmator block,

            I use Icprog and Ponyprog, but ponyprog not function never.

            tanks

            Comment


            • #21
              ...........

              Comment


              • #22
                Originally posted by tatillo View Post
                I use multitito and ponyprog 24xx,25xx,3xx v1.0

                I hope that this dump is right.

                I have some problem to read, sometime the programmator block,

                I use Icprog and Ponyprog, but ponyprog not function never.

                tanks
                Bad read friend ... try again.
                You try read onboard or out eeprom ?

                Radio connect +12v or not ?
                A little more detail please

                Comment


                • #23
                  I tried with radio connect +12v onboard and without +12v and tried tree programmator but there are problem

                  Comment


                  • #24
                    Better read to take eeprom from board.

                    You have hot air soldering iron for out eeprom ? :confused5:

                    Comment


                    • #25
                      yes i have but now i can't because my hot air soldering iron is lot rumor and now people slip but a can try with normal station soldering.

                      Comment


                      • #26
                        You connect two wire power +12v ? if not try this.
                        ------------
                        Do not try with normal station soldering -- If you not worked before !

                        What are the voltage on all pins 1=? 2=? 3=? .... 8=?

                        Comment


                        • #27
                          i hope

                          i tried in all mode but is strange dump.

                          in pin vcc volt 5

                          in pin sda volt -065

                          in pin scl 2.19

                          Comment


                          • #28
                            every time that i read return a different dump

                            Comment


                            • #29
                              meaby

                              Maybe it's right dump

                              Comment


                              • #30
                                Originally posted by tatillo View Post
                                every time that i read return a different dump
                                Yeesss !arty:

                                Code +++++ 1986 +++++

                                Comment

                                Working...
                                X