Would somebody know the DIP Switch settings for this Autel Maxysis MY908?
I am looking to enter bootloader mode/ recovery
So far standard is dip 1 and 3 on, the rest are all off for normal boot (i hope that helps somebody)
If all pins are off except pin 4 "on", tablet goes into SEC S5PC110 TEST B/D
but it will only stay on that mode as long as i have the power button pressed, if i release it, it will turn off.
Even with power button held pressed, it will reset and turn off after 8 seconds, so not enough time really to access this mode.
Alternately if somebody knows the jtag points, that would help also.
Thanks to all members

Pic below:
20190523_203833.jpg - Google Drive