Hello All,
I have some Sprint Samsung S3 SPH-L710 phones that are hard bricked. I bought this Riff box to try to bring them back but I get this error:
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG Manager Version: 1.56
Selected Resurrector: [Samsung SPH-L710 V1.0.4714.55098]
Connecting to the dead body...OK
Detected dead body ID: 0x406B10E1 - CORRECT!
Set I/O Voltage reads as 1.81V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...FAILED
ERROR: No response from the RIFF Box.
I have looked around on the forums here and the only response is to change the RTCK or TCK Speeds which I have done on every option and I reach the same result.
Can anybody help me or redirect to a solution I am in dire need here
I have some Sprint Samsung S3 SPH-L710 phones that are hard bricked. I bought this Riff box to try to bring them back but I get this error:
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG Manager Version: 1.56
Selected Resurrector: [Samsung SPH-L710 V1.0.4714.55098]
Connecting to the dead body...OK
Detected dead body ID: 0x406B10E1 - CORRECT!
Set I/O Voltage reads as 1.81V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...FAILED
ERROR: No response from the RIFF Box.
I have looked around on the forums here and the only response is to change the RTCK or TCK Speeds which I have done on every option and I reach the same result.
Can anybody help me or redirect to a solution I am in dire need here
Comment