Renault Twingo Radio Code RDD101

[twingo]

Entering radio code when only the word "CODE" displayed no blinking zeroes

8312 is the original manufacturer's code, however I suspect incorrect code entry procedure.
The code is entered using the steering wheel stalk controls.
Here's some instructions.

Standard Renault Radio (with Dashboard Display) Code Entry Instructions

* Switch Radio On - The Display will show 'CODE' quickly
* followed by '0000' with the first "0" digit flashing.

Hello, and sorry to wake up such an old thread but being a new user/first poster my resources are limited

So in my case the problem is that I entered a wrong code ONCE (being lazy to check the paperwork and tried to do it from the top of my head) and now I have only the word "CODE" shows up without changing to the blinking zeroes.
As one week has been gone already I assume it's not a kind of "time delay" function but it's blocked.

Is it possible to unlock to a state where I can enter the correct code I have?
As I have only switched it on for 3-4 times for a couple seconds each to check -I wonder if there is still a time delay function and I need to leave it on for longer? (you know hope never dies )

Model No: 22DC239/62R - Single CD player/Radio with built in display for a 2002 Twingo

Any suggestions?

Thanks

[pj.benjamins]

Wow, that worked fine for me.

Many thanks.

You see, the code is not the only thing that's necessary to unlock your radio. I wouldn't have found out without your help.

thanx again.

Greetings,

Patrick Benjamins
Netherlands

[bonus]

that code doesn't work.

I have to select the code and then push a button (doesn't mind which)????

What do I have to do after I entered the code? Which button do I have to select then?

8312 is the original manufacturer's code, however I suspect incorrect code entry procedure.
The code is entered using the steering wheel stalk controls.
Here's some instructions.

Standard Renault Radio (with Dashboard Display) Code Entry Instructions

* Switch Radio On - The Display will show 'CODE' quickly
* followed by '0000' with the first "0" digit flashing.

1 Rotate "Thumbwheel" until First Correct Digit of Code Displays
2 Press the [¬ ] button on the Stalk Control to Enter in the FIRST Digit
3 The Second Digit '0' will now flash.
4 Repeat process (1) & (2) for both the correct Second and Third Digits of the code.
5 When the fourth digit flashes '0', use the thumbwheel again to bring up
the correct fourth digit on the display.
6 You now have the correct code displayed with the fourth digit flashing.
However, this time you need to hold the [¬ ] button on the stalk control
for at least 10 seconds. This process activates the code.

[pj.benjamins]

that code doesn't work.

I have to select the code and then push a button (doesn't mind which)????

What do I have to do after I entered the code? Which button do I have to select then?

[bonus]

Hi I need the code since I replaced my battery. Now my radio is asking for a code I don't know.

MODEL NO: RENRDD101-20

PROD NO: FD0004290019179

Security: I815

8200403535TI815

I'l put all my trust in you.

Thanks and regards,

Patrick Benjamins
The Netherlands

Hi Patrick
Try code 8 3 1 2
Let me know of success.
Cheers.



(remem thanks button if post useful)

[pj.benjamins]

Hi I need the code since I replaced my battery. Now my radio is asking for a code I don't know.

MODEL NO: RENRDD101-20

PROD NO: FD0004290019179

Security: I815

8200403535TI815

I'l put all my trust in you.

Thanks and regards,

Patrick Benjamins
The Netherlands