Announcement

Collapse
No announcement yet.

corsa R reg radio code required

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • corsa R reg radio code required

    Hello
    Any body knows the radio code for r reg corsa
    Serial no
    Gm 1300v6725592
    7 645 852 320

  • #2
    Originally posted by vidmalik
    Hello
    Any body knows the radio code for r reg corsa
    Serial no
    Gm 1300v6725592
    7 645 852 320
    Try code 4288

    Comment


    • #3
      Thanks I am trying to put the code in but radio goes in to 7 safe mode
      What shall I do...??

      Comment


      • #4
        Originally posted by vidmalik
        Thanks I am trying to put the code in but radio goes in to 7 safe mode
        What shall I do...??
        Read here:

        Vauxhall CAR 300 (D)
        90 532 620
        Blaupunkt 7 645 852 320



        As originally fitted to :

        Vauxhall

        This radio is designed to fit Vauxhall vehicles that utilise a seperate display on the dashboard. It cannot be used in other vehicles that do not have this seperate display fitted.

        Please note that code entry is only possible with the ignition switched on, and when four lines are shown in the seperate display. If the display continually shows "SAFE" and a number less than "10" then the unit may be codelocked and will need to be left switched on up for up to two hours to reset before another code entry attempt is possible. If it does not reset after this time, or the display shows "SAFE" with no number to the left, then you are not following the correct code entry procedure, and your ignition has not been switched on. If all of your code entry attempts have been used up, the unit will need to be sent to us to be decoded and reset. Please contact us for the cost of this service.


        Code Entry as Follows:

        Switch On Ignition (No Need To Start Engine)
        Turn Off Stereo
        Press & Hold Preset " AS " and
        Switch Radio On - Display Shows
        " SAFE " And Then Shows " 10 - - - - "
        Press preset " 1 " repeatedly for 1st Digit
        Press preset " 2 " repeatedly for 2nd Digit
        Press preset " 3 " repeatedly for 3rd Digit
        Press preset " 4 " repeatedly for 4th Digit
        If the correct code number is now shown
        Press & Hold Preset " AS " Until the Unit Beeps

        Comment


        • #5
          Originally posted by vidmalik
          Thanks I am trying to put the code in but radio goes in to 7 safe mode
          What shall I do...??
          Leave it SWITCHED ON...UNDISTURBED until it has automatically reset itself

          This could take an hour or longer

          4288 is the correct for for the Serial Number quoted

          Comment

          Working...
          X