Tweet
Hello All,
I need help resurrecting some bricked SPH-L710 Sprint S3 phones. I have a Moorc JPIN adapter for the S3 phones and the JTAG Manager sees the phones. But I get an error of no response from the RIFF Box when resurrecting:
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG Manager Version: 1.56
Selected Resurrector: [Samsung SPH-L710 V1.0.4714.55098]
Connecting to the dead body...OK
Detected dead body ID: 0x406B10E1 - CORRECT!
Set I/O Voltage reads as 1.81V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...FAILED
ERROR: No response from the RIFF Box.
I searched the forums and the only answer I got was to change the RTCK speed which I did to no success.
Also, on another SPH-L710 bricked phone I received this:
Detected an Initialized FLASH1 Chip, ID: 0x0015/0x0000 (MBG8FB, 0x000747C00000 Bytes = 29.12 GB)
Detected an Initialized FLASH2 Chip, ID: 0x0015/0x0000 (MBG8FB, 0x000000200000 Bytes = 2.00 MB)
ERROR: No Resurrection Data is available for the eMMC Chip with Capacity = 29.12GB
Can anybody help me with these to get the resurrection feature to unbrick these paperweights. JTAG MGR version is 1.56. Riff Box version is updated at 1.37.
Regards,
V
I need help resurrecting some bricked SPH-L710 Sprint S3 phones. I have a Moorc JPIN adapter for the S3 phones and the JTAG Manager sees the phones. But I get an error of no response from the RIFF Box when resurrecting:
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG Manager Version: 1.56
Selected Resurrector: [Samsung SPH-L710 V1.0.4714.55098]
Connecting to the dead body...OK
Detected dead body ID: 0x406B10E1 - CORRECT!
Set I/O Voltage reads as 1.81V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...FAILED
ERROR: No response from the RIFF Box.
I searched the forums and the only answer I got was to change the RTCK speed which I did to no success.
Also, on another SPH-L710 bricked phone I received this:
Detected an Initialized FLASH1 Chip, ID: 0x0015/0x0000 (MBG8FB, 0x000747C00000 Bytes = 29.12 GB)
Detected an Initialized FLASH2 Chip, ID: 0x0015/0x0000 (MBG8FB, 0x000000200000 Bytes = 2.00 MB)
ERROR: No Resurrection Data is available for the eMMC Chip with Capacity = 29.12GB
Can anybody help me with these to get the resurrection feature to unbrick these paperweights. JTAG MGR version is 1.56. Riff Box version is updated at 1.37.
Regards,
V
Comment