N7100 KMV3W000LM-B310 Emmc Boot File

[ZameerAhmed]

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.51 (RIFFBOX1), JTAG Manager Version: 1.81
Selected Resurrector: [Samsung N7100 ISP V1.0.6474.43852, <JTAG>, 1 Bit Bus Width (DAT0)]

Connecting to the SD/eMMC Card...OK
Set I/O Voltage reads as 3.25V, SD_CLK Frequency is 400 KHz

Memory Type ........................... eMMC
Manufacturer ID ....................... 0x15
OEM/Application ID ................... 0x00
Product Name ......................... "V3W00M"
Package .................................. BGA
User Area Partition Size ............. 0x0003AB400000 Bytes (14.68 GB)
Boot Partition Size .................... 0x000000400000 Bytes (4.00 MB)
RPMB Partition Size ................... 0x000000080000 Bytes (512.00 KB)
OCR Register ............................ 0xC0FF8080 (Dual Voltage, High Capacity)
Write Protection Bits .................. NONE
ExtCSD Register Fields ............... [177] = 0x01, [179] = 0x48, [162] = 0x00
Boot Configuration .................... Boot from Boot Partition 1 (Bus Width = 4 Bits)
Chip Revision ............................ 0.0
Multimedia Card Revision ........... 1.7 (eMMC v5.0)
Serial Number ........................... 0x34A34C45
Memory Manufacturing Date ........ June, 2014


Thanks

[Legija]

Just write bootloader tar using eMMC plugin, that should suffice.

[ZameerAhmed]

Mr.Legija Where to Find N7100 Bootloader tar can you give me link

please

[Legija]

Here You go.


Note that phone must have GPT and PIT in user area partition.
I see that ISP resurrector has bad data, so that could be the problem, so please give me few minutes to prepare valid file.

[Legija]

Ok, so there seems to be small glitch with plugin, nothing important.


1. Make resurrection
2. Start eMMC Plugin, click "Parse connected "
3. Click "Parse official firmware" and select bootloader tar.md5 file
4. Click "Flash selected partitions full".


After this phone must enter download mode if HW is okay.