Oppo a3s dead,!!!!

[med9306]

Halloo
I have oppo a3s dead after reset user code
online qualcomm mode
please dump for oppo a3s tanks

[deni29]

Halloo
I have oppo a3s dead after reset user code
online qualcomm mode
please dump for oppo a3s tanks

check CLK,,if damage remove it and make jumper.

[med9306]

check CLK,,if damage remove it and make jumper.

i mark jumper the same problem

[Legija]

Its not possible to kill any phone with riff factory reset.

Please describe exactly what you have done, and with what?

[deni29]

i mark jumper the same problem

when device become quallcom mode after direct isp.any smd damage caused by over heat when you do soldering wire.remove CLK and do jumper it.

[sewren]

i have the same issue dead after wipe data phone detected in qcomm mode

i remove CLK and do jumper same proble phone detected in qcomm mode .... my a3s model is cph1803

[Legija]

CMD resistor = 10K
CLK resistor = 24 Ohm


There is only two possible reasons for phone to go dead:
1. Overheated elements during shield removal (If shield removed by heat)
2. Damaged prints/parts during soldering.


Software just writes commands to MISC partition and this can not cause bootloader to fail.

[med9306]

Plesse help me for wirte dump a3s in box riff tanks

[Legija]

Plesse help me for wirte dump a3s in box riff tanks

Please explain EXACTLY what You have done to phone and with what.

Writing dump can make permanent damage to phone.
If You want our help, You need to cooperate.

[med9306]

After reset password with isp riffbox téléphone entre edl mode

[med9306]

I have already tried soldering wire.remove CLK and do jumper

[Legija]

So, let's confirm:

1. You removed shield how ? Cut out with cutters or removed with hot air gun ?

2. You soldered wires, and selected "Wipe Data" in Oppo A3s model ?

3. You desoldered wires and assembled phone, phone is dead ?

4. You removed CLK resistor and shorted two points, phone still dead ?

[med9306]

1 Cut out with cutters
2 yes Wipe Data
3 phone is dead
4 i removed CLK resistor and shorted two points

[Legija]

My suggestion is to carefully clean the board and review all parts with microscope. There must be something damaged.

[med9306]

If possible way help me for flash a3s avec isp
thank you for all