Announcement

Collapse
No announcement yet.

Motorola v3...I can't unlock it with Rocker Dongle..WHY? please help me!

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Motorola v3...I can't unlock it with Rocker Dongle..WHY? please help me!

    Hello, I need help to unlock a Motorola V3

    Bootloader 0A.52
    Firmware R4515_G_08.BD.E1R


    using Rocker Dongle device...please...give me some help ASAP. All this is without TP or not?

    Thanks in advance

    Please, answer me ASAP.
    ..:: Improving this box to the top ::..

  • #2
    Originally posted by chatfan View Post
    Hello, I need help to unlock a Motorola V3

    Bootloader 0A.52
    Firmware R4515_G_08.BD.E1R


    using Rocker Dongle device...please...give me some help ASAP. All this is without TP or not?

    Thanks in advance

    Please, answer me ASAP.

    See attachment....boot 0A.52 need TP, but you can do the following:

    Do TP, click REPAIR, this downgrades boot to version 0A.30 so you can operate phone as usual, unlock without TP, repair IMEI, or even flash it without any problems.

    Regards.-

    Comment


    • #3
      But where I get the picture to do TP? for this model? please help me....
      ..:: Improving this box to the top ::..

      Comment


      • #4
        Originally posted by chatfan View Post
        But where I get the picture to do TP? for this model? please help me....
        From support ofcourse :ihih:

        Comment


        • #5
          So? it worked or not? :confused5:

          Comment


          • #6
            Get this error "Access denied. Try to boot with testpoint" with test point
            GSM PHONES :aureola:

            Comment


            • #7
              Originally posted by glontz View Post
              Get this error "Access denied. Try to boot with testpoint" with test point
              Wrong testpoint procedure, check good contact with testpoint and ground, and procedure too, you must connect testpoint before give power to pcb, when it is detected as S FLash then release tespoint.

              Maybe try another testpoint also, check correct V3 model.

              Regards.-

              Comment


              • #8
                i use smart TP and work another v3 probably this have a problem, i make by code :|
                GSM PHONES :aureola:

                Comment


                • #9
                  Originally posted by glontz View Post
                  i use smart TP and work another v3 probably this have a problem, i make by code :|
                  Then you go ahead and throw your dongle in the trash if you can't figure it out. V3, V3r and V3i's have been supported for so long with or without testpoint.
                  I do Testpoints for Breakfast

                  Comment


                  • #10
                    Originally posted by glontz View Post
                    i use smart TP and work another v3 probably this have a problem, i make by code :|
                    You're not being specific about your problem....Boot loader Version? SW Version? V3 Model??

                    You should also start a new thread, and like vermsky said, V3 it's supported long ago, so as much info you give it would be more easy to help you and faster also...

                    Regards.-

                    Comment


                    • #11
                      you just connect tp when software say to LTE 2 etc is connected then disconnect the tp unlock the phone, it is maximum 3 or 4 sec method. It is very simple method.

                      Comment

                      Working...
                      X