Hello dear members !
Since some of You still have probs using single button, here is simple abd effective manual:
Requirements:
1. Locked Motofone F3
2. Rocker Dongle or Rocker Box with activated Moto Rocker slot
3. Prolific based cable interface or FTDI one
Procedure:
Rocker Dongle Resellers
Since some of You still have probs using single button, here is simple abd effective manual:
Requirements:
1. Locked Motofone F3
2. Rocker Dongle or Rocker Box with activated Moto Rocker slot
3. Prolific based cable interface or FTDI one
Procedure:
- Power down the phone, and connect cable,
- Hold "#, *" keys and press power button to enter flash mode. Phone screen will remain blank.
- Press "UNLOCK" button and wait for "Unlocked OK" message.
- After clicking "UNLOCK" - nothing hapens - Phone not in flash mode.
- Repeat entering flash mode procedure,
- Check com port selection
- Retry after everything is checked - After progress bar comes to 100% after first step, software says "Cannot change Baud Rate""
- DO NOT use phisical com port. It will NOT WORK
- Use only USB to Serial interfaces, due to port speed requirements. - After progress bar goes to 100% - software says "Comunication Failure"
- Phone battery is empty, recharge it. - After clicking "Unlock" software says "Wrong Response"
- You dont have Rocker Dongle or Rocker Box connected
- You are using bad EnFoRcEr version
Rocker Dongle Resellers
Comment