g532f resrrection error

[knoc]

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.54 (RIFFBOX1), JTAG Manager Version: 1.89
Selected Resurrector: [Samsung G532F ISP V1.0.6599.17149, <RJ-45>, 1 Bit Bus Width (DAT0)]

Connecting to the SD/eMMC Card...OK
WARNING: Embedded I/O Voltage is overriden to 2.35V
Set I/O Voltage reads as 2.34V, SD_CLK Frequency is 649 KHz

Detected eMMC Chip, ID: 0x90/0x4A (H8G4u ), User Area Partition = 0x0001D2000000 Bytes (7.28 GB)

Analizing the FullImage File:
Looking for the MBR Signature ................... FAILEDERROR
ERROR: Wrong response from the RIFF Box.
Failed to receive answer to READ command.

ERROR: Failed to read data from the connected Device!

[knoc]

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.54 (RIFFBOX1), JTAG Manager Version: 1.89
Selected Package: [Samsung G532F XWU1ASB1 V1.09 by <legija>, <RJ-45>, 1 Bit Bus Width (DAT0)]

Connecting to the SD/eMMC Card...OK
WARNING: Embedded I/O Voltage is overriden to 1.80V
Set I/O Voltage reads as 1.80V, SD_CLK Frequency is 649 KHz

Detected eMMC Chip, ID: 0x90/0x4A (H8G4u ), User Area Partition = 0x0001D2000000 Bytes (7.28 GB)

Writting to the SD/MMC Memory...ERROR
ERROR: Timeout while waiting for DCC Loader response. Terminating at 0x000000166400

[knoc]

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.54 (RIFFBOX1), JTAG Manager Version: 1.89
Selected Resurrector: [Samsung G532F ISP V1.0.6599.17149, <RJ-45>, 1 Bit Bus Width (DAT0)]

Connecting to the SD/eMMC Card...OK
Set I/O Voltage reads as 1.80V, SD_CLK Frequency is 649 KHz

Detected eMMC Chip, ID: 0x90/0x4A (H8G4u ), User Area Partition = 0x0001D2000000 Bytes (7.28 GB)

Selected Resurrection Data for the eMMC Chip with Capacity = 7.28 GB

Flashing the dead body...
ERROR: Timeout while waiting for DCC Loader response. Terminating at 0x0000000C0000

[knoc]

i am trying to resurrect g532f that got dead after flashing stock firmware but keep getting those errors. can someone help please

[Legija]

First, make sure to follow instructions on how to prepare box for ISP connections:
RIFF JTAG Box FAQ - How to prepare RIFF Box v1/v2 for eMMC/SD protocol and ISP connection

Next, on eMMC/SD tab click "Check eMMC" click "advanced . . ." and then click "emmc write test".
At last, select Samsung G532F XXU1ARB1, and click resurrection.