No announcement yet.

J510f error

  • Filter
  • Time
  • Show
Clear All
new posts

  • J510f error

    i am using emmc adapter to connect emmc from j510 but keep getting this error, no modification done to the box. micro usb connected to the adapter.

    Open serial port...OK
    Connecting to the RIFF Box...OK
    Firmware Version: 1.54 (RIFFBOX1), JTAG Manager Version: 1.88
    Selected Resurrector: [Samsung J510FN ISP V1.0.6474.38684, <RJ-45>, 1 Bit Bus Width (DAT0)]

    Connecting to the SD/eMMC Card...ERROR
    WARNING: Embedded I/O Voltage is overriden to 3.25V
    Set I/O Voltage reads as 3.25V, SD_CLK Frequency is 960 KHz

    Connecting to the SD/eMMC Card Failed (ERR[0071], POS[0001])

  • #2
    Adapter needs pull up resistor for CLK.

    Put blue switch to ON (dat0 and cmd), add 100 ohm between VCCQ and CLK signals.
    Set VCCQ switch to 1.8v
    Set VCCQ on software to 1.8~2.2v
    Connect microusb to adapter from same PC where RIFF Box is connected.
    This setup will work given connection is made properly.
    ICQ: 299-912-089
    QQ: 1634811353


    • #3
      Please start JTAG Manager and click “Check for Updates” button. You’ll be notified about new DLL, download it and restart the software.

      “HTC_HD.dll” contains pinout, repair instructions and required files for single click HTC Touch HD Unbrick, Unlock, IMEI Change, CID Change and Model ID repair.
      SharePoint data migration | SharePoint on azure | Microsoft CRM software