Huawei P smart+ usb port 1.0 (INE-LX1)

[Mirco]

This phone after an unsuccessful reduction of the firmware crashed into USB port 1.0. There are no ways to fix it. Apparently, when lowering the firmware, the bootloader is damaged. Is it possible to restore the bootloader by a riff?

[Legija]

If there is no frp lock you can try to find board software and flash it with IDT.

[Mirco]

thanks, I'll try.

[Mirco]

it is not possible to flash it through idt. In this device soin kirin710 it in the course at the moment does not support anything. The only option is probably only through isp.

[Legija]

There is no pinout at the moment.

[Mirco]

And if I provide an ISP pinout, is it possible to make bootloader recovery files?

[Mirco]

I also have dumps made with other products

[Legija]

Yes, if you have pinout we can make repair pack.

[Mirco]

ISP pinout ine-lx1

[Legija]

Ok, I will prepare repair pack today.

[Legija]

Huawei_Nova_3i_INE-LX1_ISP.riffpkg

Save file to repairpacks folder.

[Mirco]

some interesting situation. can't download file. everything is logged in well on the forum. Going to the link says that the login password is incorrect. Although everything was fine before.

[Legija]

Turbo support requires additional registration, if you already registered there and forgot password or username then send me SN via PM.

[Mirco]

if I supply power VCC end VCCQ from the box the memory is allocated, but when trying to recover it gives a message

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.54 (RIFFBOX1), JTAG Manager Version: 1.89
Selected Package: [Huawei Nova 3i INE-LX1 V1.01 by <legija>, <RJ-45>, 1 Bit Bus Width (DAT0)]

Connecting to the SD/eMMC Card...OK
WARNING: Embedded I/O Voltage is overriden to 1.85V
Set I/O Voltage reads as 1.85V, SD_CLK Frequency is 649 KHz

Detected eMMC Chip, ID: 0x02/0x00 (SDM032), User Area Partition = 0x000001E9C000 Bytes (30.61 MB)

ERROR: Selected FLASH Chip was not initialized by the DCC Loader.ERROR


and if you do not feed from the box VCC end VCCQ, and if you connect a USB cable, the memory is not allocated

[Mirco]

but the memory is allocated a volume of only 31 MB. Does this indicate a chip failure?