I connect via RJ-45. VCC and VCCQ are out of the box. Lifting resistors CMD and DAT0 are installed.
I receive a message:
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.53 (RIFFBOX1), JTAG Manager Version: 1.88
Selected Package: [Samsung J610FN V1.02 by <legija>, <RJ-45>, 1 Bit Bus Width (DAT0)]
Connecting to the SD/eMMC Card...ERROR
Set I/O Voltage reads as 1.80V, SD_CLK Frequency is 490 KHz
Connecting to the SD/eMMC Card Failed (ERR[0071], POS[0001])
What could be the problem?
I receive a message:
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.53 (RIFFBOX1), JTAG Manager Version: 1.88
Selected Package: [Samsung J610FN V1.02 by <legija>, <RJ-45>, 1 Bit Bus Width (DAT0)]
Connecting to the SD/eMMC Card...ERROR
Set I/O Voltage reads as 1.80V, SD_CLK Frequency is 490 KHz
Connecting to the SD/eMMC Card Failed (ERR[0071], POS[0001])
What could be the problem?
Comment