Announcement
Collapse
No announcement yet.
Motorola XT1022
Collapse
X
-
Motorola_XT1022_USB.riffpkg
Motorola_XT1022_ISP.riffpkg
One of those two should work, if HW is okay. Not sure for USB version (have firehose loader from "internet").
Data taken from "XT1022_CONDOR_RETAILDSDS_5.1_LPCS23.13-34.8-3_cid7" firmware.
Comment
-
-
MBR Signature error
Firmware Version: 1.51 (RIFFBOX1), JTAG Manager Version: 1.82
Selected Resurrector: [Motorola XT-1022 ISP V1.0.6698.6650, <RJ-45>, 1 Bit Bus Width (DAT0)]
Connecting to the SD/eMMC Card...OK
Set I/O Voltage reads as 1.99V, SD_CLK Frequency is 2.50 MHz
Detected eMMC Chip, ID: 0x11/0x00 (004G90), User Area Partition = 0x0000EC000000 Bytes (3.69 GB)
Analizing the FullImage File:
Looking for the MBR Signature ................... ERROR
ERROR: Failed to read data from the connected Device!
Comment
-
That should not happen if eMMC is ok.
Click resurrection, when finish start emmc plugin and execute those steps from previous message.
Here is dump, in case You wanna try it:
eMMC tab, set user area partition, untick auto full.
Open this file,
Set address to 0x0
Data length select "File Size" (first option on drop down menu),
Click "Write".
Reading PDS backup first is advised.Attached FilesLast edited by Legija; 11-22-2018, 02:03 PM.
Comment
Comment