htc sensation 4g PG58100

[dave_21]

Htc sensation 4g PG58100 jtag failed :-(
Not connect also AnalYze Jtag Chain666.PNG
How to resolve?

[Legija]

Post log from DCC TAB or resurrection.

[dave_21]

no connect... the phone it's in work condiction but i must change cid etc...

[dave_21]

[06/11/2018 22:56:48] [START OPERATION_ID = DCC_READ_MEMORY]
[06/11/2018 22:56:48]
[06/11/2018 22:56:48] Current Settings:
[06/11/2018 22:56:48] -----------------
[06/11/2018 22:56:48] Address: 000000000000
[06/11/2018 22:56:48] Length: 000000000000
[06/11/2018 22:56:48] Address Space: RAM
[06/11/2018 22:56:48] AutoFullFlash: UNCHECKED
[06/11/2018 22:56:48] Use End Address: UNCHECKED
[06/11/2018 22:56:48] ECC Module Enabled: UNCHECKED
[06/11/2018 22:56:48] Image File is Used: UNCHECKED
[06/11/2018 22:56:48] Use Address as Offset: UNCHECKED
[06/11/2018 22:56:48] Main (UNCHECKED):
[06/11/2018 22:56:48] Redu (UNCHECKED):

[Legija]

Set fixed TCK, 8MHz for start.

[dave_21]

Not work

[Legija]

JTAG tab, click analyze jtag chain, then connect&get id.


Copy/paste log , don't make screenshots.

[dave_21]

06/11/2018 23:56:14] [START OPERATION_ID = JTAG_ANALIZE]
[06/11/2018 23:56:15] Open serial port...OK
[06/11/2018 23:56:15] Connecting to the RIFF Box...OK
[06/11/2018 23:56:15] Firmware Version: 1.51 (RIFFBOX1), JTAG Manager Version: 1.82
[06/11/2018 23:56:15] Selected Resurrector: [HTC Sensation4G (PG5810000) V1.0.4557.1904]
[06/11/2018 23:56:15]
[06/11/2018 23:56:15] Connecting to the target...OK
[06/11/2018 23:56:15] Set I/O Voltage reads as 1.80V, TCK Frequency is 8 MHz
[06/11/2018 23:56:15]
[06/11/2018 23:56:15] Following devices are found on the JTAG chain:
[06/11/2018 23:56:15] Device on TAP #0: ID = 0x0F1E0E0F, IR Length = 0x10 bits
[06/11/2018 23:56:15] Total IR length: 0x0010 bits
[06/11/2018 23:56:15] [FINISH OPERATION_ID = JTAG_ANALIZE]

[06/11/2018 23:56:15] [START OPERATION_ID = JTAG_ANALIZE]
[06/11/2018 23:56:16] Open serial port...OK
[06/11/2018 23:56:16] Connecting to the RIFF Box...OK
[06/11/2018 23:56:16] Firmware Version: 1.51 (RIFFBOX1), JTAG Manager Version: 1.82
[06/11/2018 23:56:16] Selected Resurrector: [HTC Sensation4G (PG5810000) V1.0.4557.1904]
[06/11/2018 23:56:16]
[06/11/2018 23:56:16] Connecting to the target...OK
[06/11/2018 23:56:16] Set I/O Voltage reads as 1.80V, TCK Frequency is 8 MHz
[06/11/2018 23:56:16]
[06/11/2018 23:56:16] Following devices are found on the JTAG chain:
[06/11/2018 23:56:16] Device on TAP #0: ID = 0x0F1E0E0F, IR Length = 0x05 bits
[06/11/2018 23:56:16] Device on TAP #1: ID = 0x108010E1, IR Length = 0x0A bits
[06/11/2018 23:56:16] Total IR length: 0x000F bits
[06/11/2018 23:56:16] [FINISH OPERATION_ID = JTAG_ANALIZE]

[06/11/2018 23:56:23] [START OPERATION_ID = JTAG_ANALIZE]
[06/11/2018 23:56:24] Open serial port...OK
[06/11/2018 23:56:24] Connecting to the RIFF Box...OK
[06/11/2018 23:56:24] Firmware Version: 1.51 (RIFFBOX1), JTAG Manager Version: 1.82
[06/11/2018 23:56:24] Selected Resurrector: [HTC Sensation4G (PG5810000) V1.0.4557.1904]
[06/11/2018 23:56:24]
[06/11/2018 23:56:24] Connecting to the target...OK
[06/11/2018 23:56:24] Set I/O Voltage reads as 1.80V, TCK Frequency is 8 MHz
[06/11/2018 23:56:24]
[06/11/2018 23:56:24] Following devices are found on the JTAG chain:
[06/11/2018 23:56:24] Device on TAP #0: ID = 0x4F1E0F0F, IR Length = 0x04 bits
[06/11/2018 23:56:24] Device on TAP #1: ID = 0x004210E1, IR Length = 0x0B bits
[06/11/2018 23:56:24] Total IR length: 0x000F bits
[06/11/2018 23:56:24]
[06/11/2018 23:56:24] Analizing IDCODE(s) of the JTAG scan chain:
[06/11/2018 23:56:24] 1. 0x004210E1: Qualcomm MSM8260, H/W Rev. #0
[06/11/2018 23:56:24] [FINISH OPERATION_ID = JTAG_ANALIZE]

[dave_21]

[06/11/2018 23:59:11] [START OPERATION_ID = GET_DEVICE_ID]
[06/11/2018 23:59:11] Open serial port...OK
[06/11/2018 23:59:11] Connecting to the RIFF Box...OK
[06/11/2018 23:59:11] Firmware Version: 1.51 (RIFFBOX1), JTAG Manager Version: 1.82
[06/11/2018 23:59:11] Selected Resurrector: [HTC Sensation4G (PG5810000) V1.0.4557.1904]
[06/11/2018 23:59:11]
[06/11/2018 23:59:11] Connecting to the dead body...ERROR
[06/11/2018 23:59:11] Set I/O Voltage reads as 1.81V, TCK Frequency is 8 MHz
[06/11/2018 23:59:11]
[06/11/2018 23:59:11] None is detected.
[06/11/2018 23:59:11] [FINISH OPERATION_ID = GET_DEVICE_ID]

[06/11/2018 23:59:11] [START OPERATION_ID = GET_DEVICE_ID]
[06/11/2018 23:59:12] Open serial port...OK
[06/11/2018 23:59:12] Connecting to the RIFF Box...OK
[06/11/2018 23:59:12] Firmware Version: 1.51 (RIFFBOX1), JTAG Manager Version: 1.82
[06/11/2018 23:59:12] Selected Resurrector: [HTC Sensation4G (PG5810000) V1.0.4557.1904]
[06/11/2018 23:59:12]
[06/11/2018 23:59:12] Connecting to the dead body...ERROR
[06/11/2018 23:59:12] Set I/O Voltage reads as 1.81V, TCK Frequency is 8 MHz
[06/11/2018 23:59:12]
[06/11/2018 23:59:12] None is detected.
[06/11/2018 23:59:12] [FINISH OPERATION_ID = GET_DEVICE_ID]

[Legija]

Are You sure that all pins have good connection ? This looks like some pin is not connected.


As for log, You can copy log from software interface, no need to post here date/time from log file.

[dave_21]

all pin are solder ok and i test connection with tester :-(

[Legija]

To me it looks like some pin is missing.

Just in case, try with usb cable, without battery, and holding power button. Otherwise double check soldering and make sure that everything is connected properly.


There is chance that pinout might be wrong, but highly unlikely.


edit:


Just found this in archive:

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.34, JTAG Manager Version: 1.48
Selected Resurrector: [HTC Sensation4G (PG5810000) V1.0.4557.1904]

Connecting to the dead body...OK
Detected dead body ID: 0x104210E1 - CORRECT!
Set I/O Voltage reads as 1.81V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

Detected an Initialized FLASH1 Chip, ID: 0x0015/0x0000 (MLL00M, 0x000090000000 Bytes = 2.25 GB)
Detected an Initialized FLASH2 Chip, ID: 0x0015/0x0000 (MLL00M, 0x000000080000 Bytes = 0.50 MB)

Flashing the dead body...OK
Resurrection complete!

This is very old phone and tested already.

[dave_21]

:-( i have used two cable ...i don't now where is the problem ,it's a simple pinout very easy solder... cable are tested (i used riff 6 years :-) ) strange problem i'm not able to repair original imei the phone have s-off and special cid ,i have tryed by irkey and give me error located imei ...strange problem.
Thanks Boss

[Legija]

You can write CID and IMEI via adb. Read info and list partitions, cant remember now exactly but should be prod_info or like that.
dd to sd card, manual probably exists on xda dev.


Root - [guide]How to superCID | Android Forums