Lumia 520 Boot Repair Problem

[4G-TELECOM]

Emmc connecting ok

Memory Type .......................... eMMC
Manufacturer ID ...................... 0x90
OEM/Application ID ................... 0x4A
Product Name ......................... "H8G2d "
Package .............................. BGA
User Area Partition Size ............. 0x0001CE800000 Bytes (7.23 GB)
Boot Partition Size .................. 0x000000200000 Bytes (2.00 MB)
RPMB Partition Size .................. 0x000000200000 Bytes (2.00 MB)
OCR Register ......................... 0xC0FF8080 (Dual Voltage, High Capacity)
Write Protection Bits ................ NONE
ExtCSD Register Fields ............... [177] = 0x00, [179] = 0x38, [162] = 0x01
Boot Configuration ................... Boot from User Area (Bus Width = 1Bit)
Chip Revision ........................ 0.1
Multimedia Card Revision ............. 1.5 (eMMC v4.41)
Serial Number ........................ 0x004C609A
Memory Manufacturing Date ............ March, 2013

Resurrection error
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.48 (RIFFBOX1), JTAG Manager Version: 1.74
Selected Resurrector: [Nokia Lumia 520 ISP V1.0.6444.62826]

Connecting to the SD/eMMC Card...OK
Set I/O Voltage reads as 1.80V, SD_CLK Frequency is 2.50 MHz

Detected eMMC Chip, ID: 0x90/0x4A (H8G2d ), User Area Partition = 0x0001CE800000 Bytes (7.23 GB)

Selected Resurrection Data for the eMMC Chip with Capacity = 7.23 GB

Flashing the dead body...
ERROR: Timeout while waiting for DCC Loader response. Terminating at 0x0000000C0000

[4G-TELECOM]

No Response Mr.Legija

[mehulkr76]

these phones can be repaired using 9008 port no need to boot repair emmc

[4G-TELECOM]

these phones can be repaired using 9008 port no need to boot repair emmc

Yes know
but test riff box emmc activation

[BOSS2017]

Put Full Charged Battery & Connect USB cable From PC then Try Again...

Connect CLK, CMD, DATA0 & GND in PCB,
And For VCC & VCCQ Use USB Cable, Sometime need Battery (For Lumia)