Hello, has anyone successfully managed to read the eMMC for Galaxy S3 (i9300). I'm using Riff-2 + VR-Table so, no soldering needed.
My setup is working with other phones, but not with this Galaxy S3. My only guess is that there's a lot of glue/coating around the chip, and one pin must be connected in that area.
Could it be other reason like not being able to bypass the controller?
*Phone is working, I'm performing some data recovery tests.
My setup is working with other phones, but not with this Galaxy S3. My only guess is that there's a lot of glue/coating around the chip, and one pin must be connected in that area.
Could it be other reason like not being able to bypass the controller?
*Phone is working, I'm performing some data recovery tests.
Comment