Tweet
Attempted to resurrect above named device and failed
Here is my log:
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.41 (RIFFBOX1), JTAG Manager Version: 1.61
Selected Resurrector: [ASUS Padfone A68 V1.0.5019.4304]
Connecting to the dead body...OK
Detected dead body ID: 0x107190E1 - IGNORED!
Set I/O Voltage reads as 1.81V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
Detected an Initialized FLASH1 Chip, ID: 0x0090/0x014A (HBG4E, 0x000748000000 Bytes = 29.13 GB)
Detected an Initialized FLASH2 Chip, ID: 0x0090/0x014A (HBG4E, 0x000000200000 Bytes = 2.00 MB)
No Resurrection Data is available for the eMMC Chip with Capacity = 29,13GB
WARNING!!! Using Resurrection Data for the eMMC Chip with Capacity = 58,25GB
Flashing the dead body...
ERROR: DCC Loader has reported Error Code = 0x51 (0x000000). Trying to recover...OK
ERROR: DCC Loader has reported Error Code = 0x51 (0x000000). Trying to recover...OK
ERROR: DCC Loader has reported Error Code = 0x51 (0x000000). Trying to recover...OK
ERROR: Stopped due to multiple communication errors. Terminating at 0x000000000000
where to get correct resurrector?
Or there is possibility to modify it?
Here is my log:
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.41 (RIFFBOX1), JTAG Manager Version: 1.61
Selected Resurrector: [ASUS Padfone A68 V1.0.5019.4304]
Connecting to the dead body...OK
Detected dead body ID: 0x107190E1 - IGNORED!
Set I/O Voltage reads as 1.81V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
Detected an Initialized FLASH1 Chip, ID: 0x0090/0x014A (HBG4E, 0x000748000000 Bytes = 29.13 GB)
Detected an Initialized FLASH2 Chip, ID: 0x0090/0x014A (HBG4E, 0x000000200000 Bytes = 2.00 MB)
No Resurrection Data is available for the eMMC Chip with Capacity = 29,13GB
WARNING!!! Using Resurrection Data for the eMMC Chip with Capacity = 58,25GB
Flashing the dead body...
ERROR: DCC Loader has reported Error Code = 0x51 (0x000000). Trying to recover...OK
ERROR: DCC Loader has reported Error Code = 0x51 (0x000000). Trying to recover...OK
ERROR: DCC Loader has reported Error Code = 0x51 (0x000000). Trying to recover...OK
ERROR: Stopped due to multiple communication errors. Terminating at 0x000000000000
where to get correct resurrector?
Or there is possibility to modify it?