Tweet
Connecting to the target...OK
Set I/O Voltage reads as 1.80V, TCK Frequency is RTCK
Following devices are found on the JTAG chain:
Device on TAP #0: ID = 0x4F1F0F0F, IR Length = 0x04 bits
Device on TAP #1: ID = 0x105310E1, IR Length = 0x0B bits
Total IR length: 0x000F bits
Analizing IDCODE(s) of the JTAG scan chain:
1. 0x105310E1: Qualcomm MSM8660, H/W Rev. #1
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.41 (RIFFBOX1), JTAG Manager Version: 1.62
Selected Resurrector: [LG LU6200 V1.0.5025.52349]
Connecting to the dead body...OK
Detected dead body ID: 0x105310E1 - CORRECT!
Set I/O Voltage reads as 1.79V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
Detected an Initialized FLASH1 Chip, ID: 0x0006/0x0000 (16, 0x0000D7800000 Bytes = 3.37 GB)
Detected an Initialized FLASH2 Chip, ID: 0x0006/0x0000 (16, 0x000000200000 Bytes = 2.00 MB)
Flashing the dead body...
WARNING: Programming Error (0x25) at 0x000000000000 is handled as Cut Excess.
ERROR: DCC Loader has reported Error Code = 0x3E (0x007FFF <> 0x020000)
Set I/O Voltage reads as 1.80V, TCK Frequency is RTCK
Following devices are found on the JTAG chain:
Device on TAP #0: ID = 0x4F1F0F0F, IR Length = 0x04 bits
Device on TAP #1: ID = 0x105310E1, IR Length = 0x0B bits
Total IR length: 0x000F bits
Analizing IDCODE(s) of the JTAG scan chain:
1. 0x105310E1: Qualcomm MSM8660, H/W Rev. #1
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.41 (RIFFBOX1), JTAG Manager Version: 1.62
Selected Resurrector: [LG LU6200 V1.0.5025.52349]
Connecting to the dead body...OK
Detected dead body ID: 0x105310E1 - CORRECT!
Set I/O Voltage reads as 1.79V, TCK Frequency is RTCK
Adaptive Clocking RTCK Sampling is: [Sample at MAX]
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
Detected an Initialized FLASH1 Chip, ID: 0x0006/0x0000 (16, 0x0000D7800000 Bytes = 3.37 GB)
Detected an Initialized FLASH2 Chip, ID: 0x0006/0x0000 (16, 0x000000200000 Bytes = 2.00 MB)
Flashing the dead body...
WARNING: Programming Error (0x25) at 0x000000000000 is handled as Cut Excess.
ERROR: DCC Loader has reported Error Code = 0x3E (0x007FFF <> 0x020000)