i9100 resurector solution needed....

[sumit070]

here is error log

Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.40 (RIFFBOX1), JTAG Manager Version: 1.62
Selected Resurrector: [Samsung I9100 V1.0.4850.415]

Connecting to the dead body...OK
Detected dead body ID: 0x4BA00477 - CORRECT!
Set I/O Voltage reads as 2.79V, TCK Frequency is 8 MHz

Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK

WARNING: DCC Loader was unable to initialize FLASH1 chip. Error code: 0x03010043

No Resurrection Data is available for the eMMC Chip with Capacity = 0B
WARNING!!! Using Resurrection Data for the eMMC Chip with Capacity = 14.68GB

ERROR: Selected FLASH Chip was not initialized by the DCC Loader.

[mtk6572s4clone]

No Resurrection Data is available for the eMMC Chip with Capacity = 0B

Looks like emmc dead or not detected...

Try to connect directly to emmc.

Pinout:


Greetings.

[sumit070]

yes i connect with atf also and emmc detected but other option not work like write boot1 & user data also...any other solution like write dump or others