problems with a connection to the flash on the isp

[alexincor]

last update riff and manager, a flash plugged h9tp32a8jdmc.
Boxing's log
[19.05.2016 19:29:51] [START OPERATION_ID = 27]
[19.05.2016 19:30:21] Открытие порта...OK
[19.05.2016 19:30:21] Подключение к RIFF Боксу...OK
[19.05.2016 19:30:21] Версия Прошивки: 1.39 (RIFFBOX1), Версия JTAG Manager: 1.59
[19.05.2016 19:30:21]
[19.05.2016 19:30:21] Connecting to the SD/eMMC Card...ОШИБКА
[19.05.2016 19:30:21] Выставленное I/O Напряжение 3.35V, SD_CLK Frequency is 960 KHz
[19.05.2016 19:30:21]
[19.05.2016 19:30:21] Connecting to the SD/eMMC Card Failed (ERR[0077], POS[0033])
[19.05.2016 19:30:21] [FINISH OPERATION_ID = 27]
Now log on without supplying power flash
[19.05.2016 19:52:03] [START OPERATION_ID = 27]
[19.05.2016 19:52:03] Открытие порта...OK
[19.05.2016 19:52:03] Подключение к RIFF Боксу...OK
[19.05.2016 19:52:03] Версия Прошивки: 1.39 (RIFFBOX1), Версия JTAG Manager: 1.59
[19.05.2016 19:52:03]
[19.05.2016 19:52:03] Connecting to the SD/eMMC Card...ОШИБКА
[19.05.2016 19:52:03] Выставленное I/O Напряжение 3.29V, SD_CLK Frequency is 960 KHz
[19.05.2016 19:52:03]
[19.05.2016 19:52:03] Connecting to the SD/eMMC Card Failed (ERR[0075], POS[000B])
[19.05.2016 19:52:03] [FINISH OPERATION_ID = 27]
evident that without the power error codes are different. without supplying power to vccq error code is changed to (ERR [0071], POS [0001]) found no fault description for the riff Boxing
This logic analyzer I have removed the data from the line
Link

cmd lift lines and D0 is made of 100 ohm resistor to VCC. vddi capacitor between the ground and standing on a 1 uF. supply voltage is taken from the box. Connect is about 20-30 seconds and pops up an error.

[Legija]

Two options:

1. Dead chip
2. Something is wrongly connected

[Kot_Geniy]

Increase the value of resistors 220 Om D0 and CMD

[alexincor]

nno result

[Kot_Geniy]

For eMMC Hynix DATA -51kOm, CMD- 10k and capaсitor 1uF
example EMMC_162_my_1.jpg

but I was able only to read the information

[fouadh12]

Connecting to the SD/eMMC Card Failed (ERR[0071], POS[0001])...... i have this ERROR with i9190 EMMC Sandisk (SDM032 ).