Hi All,
I'm new to this forum and would like a bit of guidance (any help whatsoever) for resurrecting a dead Autel Maxisys MY908 Android car scanner which is stuck at a blue light when powered up. The light never goes out once powered up and nothing on the screen. If disconnecting the battery, when reconnected , the unit stays off until i power it up again, then same thing , just blue light.
Seems like a corrupt boot loader,?..
When connected via USB, no signs of life unless i change pinouts on the switch in the motherboard, then it shows SEC S5PC Test B/D but only for a few seconds as i need to hold the power button on while doing that and after 10 seconds it wants to restart when held...
could not find any other combination so far.
I bought a Riff Box and i'm looking for guidance on placing the soldered points on the motherboard (photos below)
Alternately, i will need to take out the eMMC chip which is a klmbg4webc-b031 and direct solder pins for data recovery/ cloning and restoring firmware ... if i can find it anywhere..
The Autel device has similar hardware configuration to Ordroid-x or Tiny-4412 so hopefully somebody knows the pinout config for this.
I'm new to this forum and would like a bit of guidance (any help whatsoever) for resurrecting a dead Autel Maxisys MY908 Android car scanner which is stuck at a blue light when powered up. The light never goes out once powered up and nothing on the screen. If disconnecting the battery, when reconnected , the unit stays off until i power it up again, then same thing , just blue light.
Seems like a corrupt boot loader,?..
When connected via USB, no signs of life unless i change pinouts on the switch in the motherboard, then it shows SEC S5PC Test B/D but only for a few seconds as i need to hold the power button on while doing that and after 10 seconds it wants to restart when held...
could not find any other combination so far.
I bought a Riff Box and i'm looking for guidance on placing the soldered points on the motherboard (photos below)
Alternately, i will need to take out the eMMC chip which is a klmbg4webc-b031 and direct solder pins for data recovery/ cloning and restoring firmware ... if i can find it anywhere..
The Autel device has similar hardware configuration to Ordroid-x or Tiny-4412 so hopefully somebody knows the pinout config for this.
Comment