Dear all,
Currently working on moto xt1642 to test the ISP adapter. I connected with the following pin-out as per the interface.
I connected it with the adapter, here is the pic:
I didnt connected the VCCQ and VCC pinout as it is been powered by USB. But on connecting device manager shows qualcomm HS-USB 9008 mode.
Riff EMMC Read/Write shows
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.51 (RIFFBOX1), JTAG Manager Version: 1.82
Selected Manual Mode: [RJ-45, 828 KHz, 1 Bit Bus Width (DAT0), 1.80V]
Connecting to the SD/eMMC Card...ERROR
Set I/O Voltage reads as 1.81V, SD_CLK Frequency is 828 KHz
Connecting to the SD/eMMC Card Failed (ERR[0071], POS[0001])
As this is my first connection, I may be wrong but I am quite sure about my soldering.
Please guide.
Best regards
~Aju
Currently working on moto xt1642 to test the ISP adapter. I connected with the following pin-out as per the interface.
I connected it with the adapter, here is the pic:
I didnt connected the VCCQ and VCC pinout as it is been powered by USB. But on connecting device manager shows qualcomm HS-USB 9008 mode.
Riff EMMC Read/Write shows
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.51 (RIFFBOX1), JTAG Manager Version: 1.82
Selected Manual Mode: [RJ-45, 828 KHz, 1 Bit Bus Width (DAT0), 1.80V]
Connecting to the SD/eMMC Card...ERROR
Set I/O Voltage reads as 1.81V, SD_CLK Frequency is 828 KHz
Connecting to the SD/eMMC Card Failed (ERR[0071], POS[0001])
Please guide.
Best regards
~Aju
Comment