FRP Blu Studio G Pluz

[tanino]

Remove FRP as Blu Studio G Pluz
1- turn off the Cel then remove the battery
2- open NCK Dongle O BOX in my case NCK Dongle
3- Open NCK Dongle Android MTK v2.5.6.2
4- Go To choose Blu Service wing option then Click Reset FRP
5- Then connect usb then check battery Manager Depositivo who are the driver
that less than 3 minutes
Miras same process to Unlock the Full Post lol more
A grain of sand talves meresco privilejio here jejejeej
Starting META mode, wait ...
Restarting to finish, wait ....
If drivers missing, CDC Please install drivers.
This can take up to 5 minutes on slow phones.
If take too long, check device manager for drivers.
[260] Port Detected META: Gadget CDC VCOM Driver (COM260)
USB \ VID_0E8D & PID_2007 \ 5 & 330375F6 & 0 & 6
Start sync target, waiting responce .....
Baseband CPU: MT6580, E01
SW_VER: D6022_G4_W5_BLU_BMOBILE_MP_V0.0.4_S151207
HW_VER: RGK6580_WE_L_HSPA_HW
Meta mode conected ok, start reading phone ....
Phone imei [1]: 356 *************************
Phone imei [2]: 868 **************************
Simlock Info: Sim [1]
Block1 [N]: Unlocked Code: 12345678
Block2 [NS]: Unlocked Code: 56781234
Block3 [SP]: Unlocked Code: 11112222
Block4 [C]: Unlocked Code: 33334444
Block5 [SIM]: Unlocked Code: 55556666
**************************************
Simlock Info: Sim [2]
Block1 [N]: Unlocked Code: 12345678
Block2 [NS]: Unlocked Code: 56781234
Block3 [SP]: Unlocked Code: 11112222
Block4 [C]: Unlocked Code: 33334444
Block5 [SIM]: Unlocked Code: 55556666
**************************************