blaupunkt car 300(D)

[rasul7979]

Good day to all!
i hope that you all o.k.
I need a code for a blaupunkt car 300 (D)
here is the parameters:
90 541 345 - part number
GW130016038834 - serial number
Thank you very much!

[_Franky_]

Good day to all!
i hope that you all o.k.
I need a code for a blaupunkt car 300 (D)
here is the parameters:
90 541 345 - part number
GW130016038834 - serial number
Thank you very much!

read the Sticky on top !

NO MULTIPLE CODE REQUESTS ON THIS FORUM

Single free code request for personal use only (one code request every 6 months minimum)

[student]

blaupunkt car 300 (D)

halo ,I need code for blaupunkt car 300 (D)

7 645 852 520

GMO 300S2214733

CAR 300 (D) 90 532 620

I hope that someone can help me ,thank you in advance

[masterskay62]

halo ,I need code for blaupunkt car 300 (D)

7 645 852 520

GMO 300S2214733

CAR 300 (D) 90 532 620

I hope that someone can help me ,thank you in advance

Try code 0444

[student]

Try code 0444

Halo ,thank you for help ,I found just now some calculator and it said 0444 to me but it does not work

I folow this ..

Turn Off Stereo
Switch On Ignition (No Need To Start Engine)
Press & Hold Preset " AS " and
Switch Radio On - Display Shows
THEN IT BEEP ,than I
Press preset " 1 " one time
Press preset " 2 " five time
Press preset " 3 " five time
Press preset " 4 " five time
Press & Hold Preset " AS " Until the Unit Beeps ... but it does not beep

[hay88]

Halo ,thank you for help ,I found just now some calculator and it said 0444 to me but it does not work

I folow this ..

Turn Off Stereo
Switch On Ignition (No Need To Start Engine)
Press & Hold Preset " AS " and
Switch Radio On - Display Shows
THEN IT BEEP ,than I
Press preset " 1 " one time
Press preset " 2 " five time
Press preset " 3 " five time
Press preset " 4 " five time
Press & Hold Preset " AS " Until the Unit Beeps ... but it does not beep

lease note that code entry is only possible with the ignition switched on, and when four lines are shown in the seperate display. If the display continually shows "SAFE" and a number less than "10" then the unit may be codelocked and will need to be left switched on up for up to two hours to reset before another code entry attempt is possible. If it does not reset after this time, or the display shows "SAFE" with no number to the left, then you are not following the correct code entry procedure, and your ignition has not been switched on.

also please check the serial stamped in to the metal casing.